欢迎访问:保定冉创模具销售有限公司!
一键分享网站到:
服务热线
18503129119
网站首页
关于我们
产品展示
行业知识
服务流程
视频展示
生产厂区
联系我们

行业知识

当前位置:首页-行业知识

防撞墙模具的实际运用

发布时间:2020/09/03

防撞墙模具现在被广泛地应用到水泥防撞墙的生产制作当中,在使用的过程中需要按照一定的操作步骤来进行制作,这样可以确保产品的质量不会出现很大的问题,并且操作起来也是比较快捷方便的,将各个部分的单体用螺丝进行连接,尽量不要留下缝隙,缝隙会在灌浆时出现漏浆,导致生产制作不成功,在清理起来也是比较麻烦的,因为一般是进行现场浇筑的,这样如果出现漏浆的情况,这样就严重拖延了工期,是施工方不愿意见到的。防撞墙模具的长度一般都是1m左右,也有2m的,现浇成型的防撞墙模具需要使用螺丝将各个单体进行连接,连接杆将左右两个部分进行连接,上下都有,随后进行浇筑。3mm厚的钢板是完全可以承受压力的,不会发生变形,可以生产出比较合格的产品,并且在面板外焊接了筋板,这样模具的抗压能力就有了进一步的增强,很大程度上降低了出现破裂变形的情况的发生几率。面板上焊接的筋板的方式是进行点焊,点焊的方式省时省力,并且还可以减少成本。

Against a wall die has been widely applied to the concrete wall of the production in the process of using according to certain steps are needed to made, so that we can ensure the quality of the product is not a lot of problems, and also be more quick and convenient to operate, will use screws to connect each part of the monomer, try not to leave gaps, cracks will appear during grouting slurry leakage, leading to production is not successful, in cleaning up is more troublesome, because generally is carries on the in situ, so that if a leak slurry, thus serious delay the time limit for a project, is the contractor's don't want to see. The length of the anti-collision wall mold is generally about 1m or 2m. For the cast-in-place anti-collision wall mold, screws are used to connect each monomer, and the connecting rod is used to connect the left and right parts, both up and down, and then the mold is poured. The 3mm thick steel plate is completely able to bear the pressure, will not occur deformation, can produce more qualified products, and in the face of the welding of the reinforcement plate, so that the die's compressive ability has been further enhanced, to a large extent to reduce the occurrence of fracture deformation. The way to weld the rebar on the panel is spot welding, which saves time and effort, and also can reduce the cost

网站首页关于我们产品展示行业知识服务流程视频展示生产厂区联系我们
contact us联系我们
ADDRESS河北省保定市莲池区闫庄模具工业区
LANDLINE18503129119